BS 2782-11 METHOD 1102A:1981

Methods of testing plastics. Thermoplastics pipes, fittings and valves-Longitudinal reversion of pipes: immersion bath method
standard by BSI Group, 02/27/1981

  • by admin
  • Comments Off on BS 2782-11 METHOD 1102A:1981
  • BS

BS 2782-1 METHOD 101 TO 102:1956

Methods of testing plastics Effect of temperature. Methods 101 and 102. Crushing strength after heating (heat resistance), deformation at elevated temperatures
standard by BSI Group, 12/28/1956

  • by admin
  • Comments Off on BS 2782-1 METHOD 101 TO 102:1956
  • BS

JEDEC JESD 82-22.01

INSTRUMENTATION CHIP DATA SHEET FOR FBDIMM DIAGNOSTIC SENSELINES
standard by JEDEC Solid State Technology Association, 01/01/2023

ASTM C1023-10(2023)

Standard Practice for Labeling Ceramic Art Materials for Chronic Adverse Health Hazards
standard by ASTM International, 03/01/2023

ASTM C1249-18(2023)

Standard Guide for Secondary Seal for Sealed Insulating Glass Units for Structural Sealant Glazing Applications
standard by ASTM International, 02/01/2023

ASTM C1925-22

Standard Test Method for Strength Properties of Direct Hung, Suspended T-bar Type Ceiling System Components Intended to Receive Gypsum Panel Products
standard by ASTM International, 11/01/2022

ASTM D3792-16(2022)

Standard Test Method for Water Content of Coatings by Direct Injection Into a Gas Chromatograph
standard by ASTM International, 12/01/2022

ASTM D4017-22

Standard Test Method for Water in Paints and Paint Materials by Karl Fischer Method
standard by ASTM International, 12/01/2022

ASTM D4273-23

Standard Test Method for Polyurethane Raw Materials: Determination of Primary Hydroxyl Content of Polyether Polyols
standard by ASTM International, 03/01/2023

ASTM D5629-23

Standard Test Method for Polyurethane Raw Materials: Determination of Acidity in Low-Acidity Aromatic Isocyanates and Polyurethane Prepolymers
standard by ASTM International, 03/01/2023