IEC 60169-4 Ed. 2.0 b:1975

Radio-frequency connectors. Part 4: R.F. coaxial connectors with inner diameter of outer conductor 16 mm (0.63 in) with screw lock – Characteristic impedance 50 ohms (Type 7-16)
standard by International Electrotechnical Commission, 01/01/1975

  • by admin
  • Comments Off on IEC 60169-4 Ed. 2.0 b:1975
  • IEC

IEC 60154-6 Ed. 1.0 b:1983

Flanges for waveguides. Part 6: Relevant specifications for flanges for medium flat rectangular waveguides
standard by International Electrotechnical Commission, 01/01/1983

  • by admin
  • Comments Off on IEC 60154-6 Ed. 1.0 b:1983
  • IEC

IEC 60137 Ed. 5.0 b:2003

Insulated bushings for alternating voltages above 1000 V
standard by International Electrotechnical Commission, 08/18/2003

  • by admin
  • Comments Off on IEC 60137 Ed. 5.0 b:2003
  • IEC

IEC 60335-2-2 Ed. 5.2 b:2006

Household and similar electrical appliances – Safety – Part 2-2: Particular requirements for vacuum cleaners and water-suction cleaning appliances CONSOLIDATED EDITION
standard by International Electrotechnical Commission, 08/29/2006

  • by admin
  • Comments Off on IEC 60335-2-2 Ed. 5.2 b:2006
  • IEC

IEC 60245-7 Ed. 1.0 b:1994

Rubber insulated cables – Rated voltages up to and including 450/750 V – Part 7: Heat resistant ethylene-vinyl acetate rubber insulated cables
standard by International Electrotechnical Commission, 07/07/1994

  • by admin
  • Comments Off on IEC 60245-7 Ed. 1.0 b:1994
  • IEC

IEC 60115-7 Ed. 1.0 b:1984

Fixed resistors for use in electronic equipment. Part 7: Sectional specification: Fixed resistor networks in which not all resistors are individually measurable
standard by International Electrotechnical Commission, 12/30/1984

  • by admin
  • Comments Off on IEC 60115-7 Ed. 1.0 b:1984
  • IEC

IEC 60130-10 Ed. 1.0 b:1971

Connectors for frequencies below 3 MHz – Part 10: Connectors for coupling an external low-voltage power supply to portable entertainment equipment
standard by International Electrotechnical Commission, 01/01/1971

  • by admin
  • Comments Off on IEC 60130-10 Ed. 1.0 b:1971
  • IEC

IEC 60122-1 Amd.1 Ed. 3.0 b:2017

Amendment 1 – Quartz crystal units of assessed quality – Part 1: Generic specification
Amendment by International Electrotechnical Commission, 12/08/2017

  • by admin
  • Comments Off on IEC 60122-1 Amd.1 Ed. 3.0 b:2017
  • IEC

IEC 60252-1 Ed. 2.0 b:2010

AC motor capacitors – Part 1: General – Performance, testing and rating – Safety requirements – Guidance for installation and operation
standard by International Electrotechnical Commission, 09/29/2010

  • by admin
  • Comments Off on IEC 60252-1 Ed. 2.0 b:2010
  • IEC

IEC 60191-6-22 Ed. 1.0 b:2012

Mechanical standardization of semiconductor devices – Part 6-22: General rules for the preparation of outline drawings of surface mounted semiconductor device packages – Design guide for semiconductor packages Silicon Fine-pitch Ball Grid Array and Silicon Fine-pitch Land Grid Array (S-FBGA and S-FL
standard by International Electrotechnical Commission, 12/11/2012

  • by admin
  • Comments Off on IEC 60191-6-22 Ed. 1.0 b:2012
  • IEC