SAE J1638_201504

• by admin
• Comments Off on SAE J1638_201504
• SAE

Click here to purchase

This SAE Recommended Practice is used for establishing the compression set that could be expected to occur with a thermoset elastomeric hose under securing clamps. It seeks to reproduce the type of indentation caused by the clamps in the wall of a hose. An excessive compression set measured by this method may indicate a hose that could eventually allow leakage of fluid or gas past the clamps in service.

Product Details

Published:

04/01/2015

File Size:

1 file , 800 KB

SAE J1638_201504

• by admin
• Comments Off on SAE J1638_201504
• SAE

Click here to purchase
This SAE Recommended Practice is used for establishing the compression set that could be expected to occur with engine coolant hoses under securing clamps. It seeks to reproduce the type of indentation caused by the clamps in the wall of the hose. An excessive compression set measured by this method would indicate a hose that could eventually alloy leakage of coolant past the clamps in service. This method has been found to give repeatable results in the range of 25% to 50% initial compression.

Product Details

Published:

04/21/2015

File Size:

1 file , 800 KB

Redline File Size:

2 files , 3.4 MB